Getting Started with Your GEM
Follow these six steps to get your GEM wearable set up: charge it, wear it correctly, download the app, pair via Bluetooth, update the firmware, and check your first data. The whole process takes about 20–30 minutes plus a 2-hour charge.
Steps:
Step 1 — Charging Your GEM
↑ Back to top- Connect the USB charging cable to the charging port on the back of the GEM.
- Plug the other end into a USB power source (wall adapter, computer, etc.).
- Red LED = charging. Green LED = fully charged.
- A full charge takes approximately 2 hours and provides up to 3 days of continuous use.
- If the light stays red after 2 hours, disconnect and reconnect — it should turn green.
Tip: Avoid extreme temperatures and charge before the battery fully depletes.
Step 2 — Wearing the GEM
↑ Back to top- Place the GEM on your wrist with the sensors facing your skin.
- Position it approximately one finger-width above your wrist bone.
- Adjust the strap so it is snug but comfortable — not too tight or loose.
- The GEM should stay in place during normal movement but not leave marks on your skin.
- Use the same wrist each time for consistent readings.
- The GEM can also be worn on the ankle.
Important: GEM Wearables are splash-proof only — do not submerge or wear in the shower or while swimming.
Step 3 — Download the App
↑ Back to topSearch for "E4L GEM" on the App Store (iOS) or Google Play Store (Android).
Android setup before opening the app
- Go to Settings → Location → turn Location ON
- Go to Settings → Bluetooth → turn Bluetooth ON
- When the app opens, allow Location access (required for Bluetooth scanning on Android) and allow Bluetooth access
Note: Bluetooth will NOT work correctly on Android without Location enabled.
iPhone setup
- Go to Settings → Bluetooth → turn Bluetooth ON
- When the app prompts, tap Allow for Bluetooth and Nearby Devices
- If needed: Settings → Apps → E4LGEM → ensure Bluetooth is enabled
Create an account using the email you used when purchasing the GEM, or log in with an existing E4L account.
Step 4 — Pair Your GEM via Bluetooth
↑ Back to top- Ensure the GEM is charged and within 30 feet of your phone.
- Enable Bluetooth on your phone.
- Open the E4L GEM app and log in.
- Tap "Add Device" on the home screen.
- Follow the on-screen instructions.
- Press the GEM button if you think Bluetooth is turned off on the device — a Blue/Green light confirms it is now on.
- The app will confirm when connected.
Step 5 — Update Firmware
↑ Back to topImportant: Do this immediately after pairing — your GEM may have firmware from when it was manufactured.
- Ensure the GEM is connected to the app (you will see a battery charge % and a blue Bluetooth icon on the home screen).
- Go to Profile (top left icon).
- Select your GEM → Manage Device screen.
- Select Update Firmware.
- Wait a few minutes — the GEM will restart automatically.
- The app will confirm when the process is complete.
Also check the App Store or Google Play Store to ensure you have the latest version of the E4L GEM app installed.
Step 6 — View Your First Data
↑ Back to topAfter connecting, the GEM will immediately begin collecting data. Initial readings will appear on the dashboard within 1–2 hours. The initial pulse reading may take a few hours to display.
| Dashboard Metric | Notes |
|---|---|
| Main Emotional Transformation | Updates continuously |
| Vitality Energy | Updated daily at 6:00 a.m. |
| Emotional Strength | Updates continuously |
| Sleep Efficiency | Beta — measures sleep quantity only; takes several days to establish a baseline |
The GEM app must be connected to the internet (Wi-Fi or mobile data) to process and display data.