Wearing Position & Fit
Wear on either wrist, 1-2 finger widths above wrist bone. Can be worn on the top or bottom of the wrist or around the ankle. Should be snug but comfortable - not cutting circulation, not sliding around.
Wrist Selection
•
Either Wrist: Left or right wrist both work
•
Preference: Choose based on comfort
•
Switching: Can switch wrists anytime
Positioning
•
Placement: 1-2 finger widths above wrist bone
•
Sensor Contact: Back of GEM must contact skin for pulse readings
•
Avoid: Too close to hand (wrist flexes), too far up arm (poor reading)
Fit Guidelines
•
Correct Fit: Snug but comfortable
•
Test: Should not slide more than 1 inch when moving wrist
•
Breathing: Skin should not bulge around strap
•
Circulation: Should not cut off circulation or leave deep marks
•
Adjustment: Tighten if pulse readings fail frequently, loosen if uncomfortable
For Accurate Readings
•
Skin Contact: Sensors on back must touch skin
•
Cleanliness: Clean skin and sensors for best readings
•
Tattoos: May interfere with readings if over pulse point
•
Movement: Minimal movement during readings (every 15 min)
Troubleshooting
Symptoms: GEM not reading pulse, pulse readings failing, GEM uncomfortable to wear, strap too tight, sensors not touching skin, GEM sliding around, poor fit on wrist
Q: My client says the GEM keeps failing to get a pulse reading — what should I check?
Q: The GEM feels uncomfortable after wearing it for a while — how should it be adjusted?
Q: The strap seems loose and the GEM is sliding around — is that a problem?
A:
Issue: Pulse readings failing
Solution: Tighten strap slightly. Ensure sensors touching skin. Clean sensors and wrist.
Issue: Uncomfortable after wearing
Solution: Loosen one notch. Switch wrists. Take breaks if needed.
Key Facts
• Either wrist works
• 1-2 finger widths above wrist bone
• Snug but comfortable fit
• Sensors must contact skin
• Should not slide freely
• Should not cut circulation