Charging Connector Cleaning & Maintenance

Clean both the GEM charging connector and cable connector with a dry cloth or cotton swab. For stubborn buildup, lightly dampen with rubbing alcohol. Let dry 30 seconds, then reconnect to test charging.


Why Cleaning Helps

Common Cause: Dust, oils from skin, and residue can build up on charging contacts over time

Prevents Connection: Buildup creates a barrier that prevents proper electrical contact

Simple Fix: Cleaning restores direct metal-to-metal contact needed for charging


Cleaning Procedure

• Disconnect GEM from charger

• Inspect both connectors - look for visible dust, lint, or residue on the metal contacts

• Gently wipe the GEM charging connector (on back of device) with a clean, dry cloth or cotton swab

• Wipe the charging cable connector (magnetic end) the same way

• For stubborn buildup: lightly dampen cloth/swab with 70% isopropyl rubbing alcohol (don't soak - just slightly damp)

• Wipe both connectors again with alcohol-dampened cloth

• Allow to air dry for 30 seconds

• Reconnect GEM to charger and check for solid red charging light


What to Use

Recommended:

• Microfiber cloth (best option - lint-free)

• Cotton swabs (Q-tips)

• Lens cleaning cloth

• 70-91% isopropyl rubbing alcohol (if needed)


Avoid:

• Paper towels (leave lint)

• Rough fabrics (can scratch contacts)

• Water (can damage device and takes too long to dry)

• Harsh chemicals (can damage coating)

• Sharp objects (can damage contacts)


Proper Charging Indicators

Normal Charging: Solid red light on GEM = charging properly

Fully Charged: Solid green light = battery at 100%

Not Charging: No light or blinking red = not charging correctly


Troubleshooting

Symptoms: GEM not charging after cleaning, charger not working, red light blinking, connector corroded, buildup on charging contacts, alcohol not removing residue, magnetic cable not connecting

Q: I cleaned the GEM connector but it's still not charging — what else can I try?

Q: The red light blinks rapidly when I plug in the charger — is this a bad connection?

Q: The charging contacts look corroded or discoloured — should I keep using alcohol on them?

A:

Issue: Still not charging after cleaning

Solution: Try different USB power adapter (use 5V/1A adapter, not fast chargers). Test cable on different power source. If still not working, contact support - may need replacement cable or device service.


Issue: Red light blinks rapidly

Solution: This indicates poor connection. Re-clean both connectors thoroughly. Ensure magnetic cable snaps firmly to GEM back - you should feel magnetic pull. Try bringing the charger close to the GEM and let the magnetic pull snap it in place.


Issue: Connector looks corroded or damaged

Solution: Do not use rubbing alcohol on corroded contacts. Contact support immediately for cable replacement or device evaluation. Continuing to charge with damaged contacts can worsen the issue.


Issue: Alcohol won't remove buildup

Solution: For stubborn residue, use fresh cotton swab with rubbing alcohol and gentle circular motions. Don't scrub hard. If buildup persists, contact support - may need professional cleaning or replacement.


Preventive Maintenance

Frequency: Clean charging contacts every 2-4 weeks with regular use

Daily Care: Wipe GEM with dry cloth before charging to remove skin oils

Storage: Keep charging cable in clean, dust-free location when not in use

Benefits: Regular cleaning prevents buildup and ensures reliable charging


Key Facts

• Clean charging contacts every 2-4 weeks

• Use dry cloth first, alcohol only if needed

• 70-91% isopropyl rubbing alcohol is safe for electronics

• Allow 30 seconds to air dry after alcohol cleaning

• Solid red light = charging correctly

• Blinking red light = poor connection

• Avoid paper towels (they leave lint)

• Never use sharp objects on contacts


Still need help?

Our assistant can answer most questions straight away, and passes anything it can't to the support team.