Charging Problems & Troubleshooting
Clean magnetic contacts with dry cloth. Ensure charger clicks firmly. Try different USB port/adapter (needs 5V/1A minimum). Red light should turn on when charging. If that does not work try a GEM reset (connect to charger and press the button for 20 seconds forcing the GEM to reset)
Common Causes
•
Dirty Contacts: Dust or debris on magnetic contacts
•
Poor Connection: Charger not aligned properly
•
Weak Power Source: USB port insufficient power (needs 5V/1A minimum)
•
Damaged Cable: Cable or magnetic connector damaged
Troubleshooting Steps
Symptoms: GEM not charging, red light not turning on, charger not connecting, charging slowly, battery percentage not increasing, magnetic contacts dirty, red light flickering, wrong power adapter
Q: My GEM won't charge — the red light isn't coming on at all. What do I do?
Q: The GEM is charging very slowly — is there a specific adapter I should use?
Q: The app shows the GEM is charging but the battery percentage isn't going up — is that a bug?
A:
• Step 1:
• action: Clean magnetic contacts
• method: Use dry cloth to clean both GEM back and charger connector
• importance: Removes dust, oils, debris that prevent connection
• Step 2:
• action: Ensure proper connection
• method: Magnetic charger should click firmly into place
• check: Try different orientations - magnets align specific way
• Step 3:
• action: Try different power source
• options: ['Different USB port on computer', 'Wall adapter (5V/1A minimum)', 'Different USB cable if available']
• avoid: Low-power USB ports (some keyboards, monitors)
• Step 4:
• action: Check for red light
• normal: Red light on front of GEM during charging
• abnormal: No light may indicate connection issue or full charge
• Step 5:
• action: Perform reset if still not charging
• method: Follow full reset procedure (see GEM-010)
• when: If charging issue persists after above steps
Power Requirements
•
Voltage: 5V
•
Amperage: 1A minimum
•
Recommended: Standard USB wall adapter or powered USB port
•
Avoid: Low-power USB ports, damaged adapters
When To Contact Support
•
Persistent Issues: Tried all troubleshooting steps
•
Physical Damage: Visible damage to charger or GEM
•
Warranty: Device under warranty - may need replacement
Troubleshooting
Symptoms: red light flickering while charging, GEM charging slowly, battery percentage stuck, charger not holding connection, slow charge, charge percentage not increasing
Q: The red light on my GEM flickers on and off while it's charging — is the connection bad?
Q: My GEM is charging really slowly — what kind of adapter should I use?
Q: The app says the GEM is charging but the battery percentage hasn't moved in an hour — what's wrong?
A:
Issue: Red light flickers during charging
Solution: Poor connection. Clean contacts. Ensure charger firmly attached. Try different power source.
Issue: Charges very slowly
Solution: Use wall adapter instead of computer USB. Ensure adapter is at least 5V/1A. Check cable not damaged.
Issue: Shows charging but percentage not increasing
Solution: May be calibration issue. Let fully discharge, then fully charge. Update firmware.
Key Facts
• Clean contacts with dry cloth first
• Charger must click firmly
• Needs 5V/1A minimum power
• Red light = charging
• Try different USB port/adapter
• Reset if issues persist
• Contact support if under warranty