NES miHealth (Gen 1) — Fails to Charge and Gets Stuck in a Loop

For the NES miHealth (Gen 1)

This article applies only to the NES miHealth (Gen 1). It does not apply to the E4L miHealth (Gen 2).

Problem:
The miHealth fails to charge when plugged in and gets stuck in a loop with a clicking sound. A date screen is shown, then it shuts down. This issue is known in version 2.02 and resolved in 2.03.

Solution:

  1. Plug the miHealth into the USB cable and power source.
  2. If the battery is empty, you will see a black screen and hear a clicking sound.
  3. Within a couple of minutes, the miHealth will start up, displaying either a date time screen or the home screen. As soon as this happens, immediately unplug the cable from the miHealth and plug it back in within a few seconds.
  4. Either the screen will remain on with the battery symbol (top-right) showing as charging, or the miHealth will turn off and show a white charging screen (you may need to touch the screen for this to show). Repeat step 3 until the miHealth stays turned on or the charging screen is shown. Leave the miHealth plugged in for 3 hours. After this time, remove it from the power, turn it on, then off again to ensure it’s not draining power after being charged. This issue is resolved in the latest software, so continue with these steps to update your miHealth.
  5. Download and install BioSync
    BioSync download for Windows
    BioSync for MAC

  6. Once installed, run the program by clicking on the Yellow Circle & white 4 desktop icon.
  7. Turn your miHealth on and connect it to your computer using the USB cable.
  8. Select miHealth updater.
  9. Click ‘Check for Updates’. Then Install Updates.
  10. The update process will take a few minutes - the miHealth will restart when the process is complete.

Still need help?

Our assistant can answer most questions straight away, and passes anything it can't to the support team.