How to calibrate your NES Health miHealth Screen

Permanently deleted user

If there is inaccuracy with the touching of the miHealth screen, you can recalibrate the screen by taking the following action.

Start with your miHealth turned off.
Make sure you have removed the plastic screen protector (this is intended to protect the screen during shipping and should not be kept on the device during use)
Reset the device by pressing and holding the two side buttons, the front right blue button and the power button.
Hold for 2 seconds.
Release the power button and the two side button but continue to hold the right hand blue button until the device turns on (this may take a few seconds).
Once the device has turned on release the blue right front button.
You should see a blue screen with 3 x -> in the top left corner of the screen. If this is not the case, please go back to the first step.
Slide the stylus out from the bottom of the right side of the miHealth.
Use the stylus or the tip of a pen to gently tap 3 times in the top left corner of the screen then in the bottom right corner.
Congratulations, your screen is now calibrated.