E4L miHealthFactory Reset
For the E4L miHealth (Gen 2)
⚠️E4L miHealth - Factory Reset
Only perform a factory reset to fix a freezing screen (see E4L miHealth: freezing, slow, or switching off during a program), or when specifically advised to by a member of the E4L support team.
Note: A factory reset will remove any custom folders on the device. You will need to re-download them after the reset is complete.
Required before starting:
- USB cable and power source (needed before confirming Recovery Mode)
- Wi-Fi network name and password ready
Watch the video attached to this article to see Part 1 & 2
Part 1 — Enter Recovery Mode
- Start with the miHealth turned off.
- Press and hold the top-left button, then press the power button to turn the device on — keep both buttons held down.
- Release both buttons when the logo appears on screen.
- The device will display a black screen with white text (the recovery menu).
- Use the top buttons to navigate to Recovery Mode.
- Plug in the USB cable before proceeding.
- Press the power button to confirm and enter Recovery Mode.
- The device will restart, display the logo for several seconds, then show a new white-text menu.
Part 2 — Wipe Data
- Use the top buttons to navigate to Wipe Data / Factory Reset.
- Press the power button to confirm.
- On the confirmation screen, select Factory Reset and confirm with the power button.
- Wait for the screen to display "Data Wipe Complete".
- Navigate to Power Off and confirm with the power button.
- The device will restart — this boot process takes longer than normal, this is expected.
Part 3 — Post-Reset Setup
Once the device has fully restarted, configure it in this order:
- Settings → Time/Date:
- Disable Automatic Date and Time
- Adjust the date and time
- Select your Region and Time Zone
Optionally enable 24-hour format
Settings → Wi-Fi: Connect to your Wi-Fi network.
Settings → Log In & Sync Data → Start Authorization:
- Email: 2@2.com
- Password: 123
After a few seconds the device will return to the home screen.
Verify programs: Go to Sessions → Programs and confirm your programs are accessible.