Troubleshooting Your E4L miHealth (Gen 2)

For the E4L miHealth (Gen 2)

For most Gen 2 miHealth issues, follow these three steps in order: check for a software update first, then perform a soft reset if needed, then reconfigure date/time and sync after the reset.

Steps:

  1. Check for a Software Update
  2. Soft Reset (Hard Reset via Button Sequence)
  3. After the Reset

Note: If these steps do not resolve the issue, escalate to the miHealth Recovery Guide or contact customerservice@E4L.com.


Step 1 — Check for a Software Update

↑ Top

The first step for any Gen 2 E4L miHealth issue is always to check for a software update. Follow the standard update instructions in the Updating & Syncing article.

If the software is already up to date, or the update is not possible, proceed to the soft reset below.

Step 2 — Soft Reset (Hard Reset via Button Sequence)

↑ Top

  1. Turn on the miHealth.
  2. Press and hold the two grey buttons (left and right).
  3. Press and release the middle button.
  4. Release the two grey buttons.
  5. A message will appear on screen asking if you want to do a hard reset — select Yes.
  6. The device will turn off.
  7. Turn the device back on.

Step 3 — After the Reset

↑ Top

Before proceeding to sync, complete the following in order:

  1. Set the date and time— this is critical, as an incorrect date/time will prevent the device from connecting to the server and downloading folders.
    • Turn off Automatic Date/Time briefly.
    • Set your Region/Country.
    • Set the Date (format: DD/MM/YYYY).
    • Set the Time.
    • Turn Automatic Date/Time back on.
  2. Connect to Wi-Fi — go to Settings → Wi-Fi and connect to your local network.
  3. Run a software update — go to Settings → Update Device.
  4. Log in and sync — enter your E4L credentials and allow the device to download your folders.

If the device still does not function correctly after completing these steps, proceed to the miHealth Recovery Guide.

Still need help?

Our assistant can answer most questions straight away, and passes anything it can't to the support team.